AUGER HOISTING ASSEMBLY

 

 

 

 

 

 

 

An auger hoisting assembly is used when it is required to pull hollow stem augers vertically utilizing the main hoist, as a part of the ground water monitoring or remediation well installation process. This technique allows the driller to pull up and back fill more than five feet at a time.

AUGER HOISTING ASSEMBLY: TRI-LOK AUGERS

Description	Lb/Kg	Part No.
3-1⁄4′ (83mm)	21(9.5)	56561030-01
4 1/4" (108MM)	24 (10.9)	56561030-02
6 5/8" (168MM)	30 (13.6)	56561030-03
8 1/4" (210MM)	28(12.7)	56561030-04
10 1/4" (260mm)	59 (26.8)	56561030-05
12 1/4" (311mm)	78 (35.4)	56561030-10

DRILLERS SERVICE, INC.                                           HICKORY, NC USA                                           800-810-0243

                                            [About Us][Products][News][Trade Shows][Contact Us]  [Previous]   [Next]

AUGER HOLDER

(4-1/4′ HSA style shown)

 

 

 

 

 

 

 

An auger holder is used to temporarily support hollow stem augers during removal of the drill string after soil sampling or monitoring  well installation has been completed. Holders are used with the auger noted in parentheses. The above design is only representative.   Other designs may vary.

 

AUGER HOLDER: LITE-FLITE AUGER

Description	Lb/Kg	Part No.
2-1⁄4′ (57mm)	10 (4.5)	565150419-01

AUGER HOLDER: TRI-LOK / 2-KEY AUGERS

Description	Lb/Kg	Part No.
3-1⁄4′ (83mm) & 4 1/4" (108MM)	33(15)	565001335
6 5/8" (168MM)	30 (13.6)	565007076
8 1/4" (210MM)	30 (13.6)	565007166
10 1/4" (260mm)	50 (22.7)	565217694
12 1/4" (311mm)	†	565150419-04