RediFlo3

These new pumps feature an all new high efficiency permanent-magnet motor that not only delivers an

ultra-high starting torque, but also provides internal protection against pump dry-run, over and under

voltage, plus overload and over-temperature safety.

The Redi-Flo3 pump-end uses a floating impeller technology and environmentally tough materials of

construction to give excellent wear resistance and solids handling capability. This meets the stringent

requirements of environmental applications.

The combination of integrated microelectronics in the pump and the optional Redi-Flo3 status box at the

surface allows communication with the pump through standard electrical motor leads. No additional wires

are required. This feature also provides the integration of multiple sensors, digital input and relays without

traditional extra electronics and cost.

The CU300 was developed for advanced control and operation of the SQE sub-

mersible pump. Two analog sensor inputs and one digital input are providedfor

controlling pump operation based on signals from external 4-20mA, 0-10vdc or

dry contact sensors. Some typical applications are constant water level mainten-

ance, float switch control or PLC control. Additionally the CU300 is supported by

optional software tools designed to provide local or remote computer access to the

CU300 displaying pump performance and offering control and configuration cap-

abilities.

CU300 Status Box Download

Installation & Operating

Instructions

The R100 infrared remote allows you to communicate with the CU300 to retrieve important pump

and performance data and change system parameters.

R100 Downloads

Installation & Operating

Instructions